The New Raspberry Pi 500+: Higher Gaming With Much less Soldering Required

When Raspberry Pi launched the Pi 500, as basically an RPi 5 built-in right into a chiclet keyboard, there have been rumors primarily based on the empty spots on the PCB that a greater model can be launched quickly. This turned out to be the case, with [Jeff Geerling] now taking the new RPi 500+ to bits for some experimentation and keyboard modding.

The 500’s case was not designed to be opened, however when you did, you’d discover that there was area allotted for a Power-Over-Ethernet part in addition to an M.2 slot, albeit with the entire footprints unpopulated. Some hacking later and enterprising folks discovered that soldering the suitable components on the PCB does in reality allow a working M.2 slot. What the five hundred+ thus does is principally try this soldering be just right for you, whereas sadly not providing a PoE characteristic but with out some DIY soldering.

Perhaps the obvious change is the keyboard, which now makes use of short-travel mechanical switches – with RGB – inside an enclosure that’s now thankfully straightforward to open, as you could wish to put in a special NVMe drive sooner or later. Or, when you’re somebody like [Jeff] you wish to use this slot to put in an M.2 to Oculink adapter for some exterior GPU motion.

After some combating eGPU gadgets an AMD RX 7900 XT was put into motion, with the AMD GPU drivers posing no problem after a kernel recompile. Other than the Oculink cable stopping the case from closing and likewise shedding the M.2 NVMe SSD possibility, it was a reasonably helpful mod to get some actual gaming and LLM motion going.

With the additions of a presoldered M.2 slot and a nicer keyboard, in addition to 16 GB RAM, it’s a must to resolve whether or not the $200 asking value is price it over the $90 RPi 500. In the case of [Jeff] his children should make do with the RPi 500 for the foreseeable future, and the RPi 400 nonetheless finds common use round his studio.